How to deal with laser marking machine technical parameters and breakdown
How to deal with laser marking machine technical parameters
When the máy khắc laser sợi quang in processing.
The direct cause of the insufficient processing of depth and processing speed are as follows :
because the effective power density of the laser processing is small.
For the same material, (note: not power), the optical power density refers to the power per unit area.
So The formula is: laser power density = laser power / laser spot area.
How to deal with laser marking machine technical parameters
So how to solve this problem :
First is increase the laser power .
The second is reducing the focused spot size.
Follow the steps :
How to deal with laser marking machine technical parameters
First,increase the laser power of final focus
1.Check the laser tube light outer and clean it . 2.Check and clean the lens damage degree , need replace the lens on time .
3.check if the light path right or with problem ,.
When the laser transmission ,is there have the following phenomenon:
Whether the laser pass through from the center , ,we need to ensure the laser pass through the center .
How to deal with laser marking machine technical parameters
Second ,Reducing the focused spot size.
According to lots of application field , it’s more effectively to reduce the spot size than enlarge Laser tube operating current. or exchange the laser tube . also it can saved cost .
Which i is the main factor for the laser spot size
Firstly , Checking the quality of the laser spot incident on the focusing lens
If the laser spot quality are much better , the spot size will; smaller , and the density of the laser will be higher .
How to deal with laser marking machine technical parameters
How to solve this situation :
As the following measures should be taken:
1. Start from the hole where the laser tube exits the hole .
Check to determine which part has caused deterioration of the quality of the laser spot.
2.If it is caused by a mirror, adjust or replace the mirror.
3.If the quality of the light exiting the laser tube has deteriorate.
the following measures should be taken:
Check whether the length of the laser tube corresponds to the distance between the support points. If necessary, adjust the support point.
How to deal with laser marking machine technical parameters
The correct distance between support points is: 1/2 of the length of the laser tube between two support points,
and the two ends are respectively 1/4. .
Also it may be the laser tube’s supporting direction is incorrect, so causing the laser tube to be deformed, and rotating the laser tube several times to find an optimal support angle (direction)
How to deal with laser marking machine technical parameters
Secondly , Choose the suitable focus lens .
For the same beam , the relationship between the focus point and the focus size :
The shorter focus length is , the focus point more smaller
June Lydia
JINAN XINTIAN TECHNOLOGY CO.,LTD
Address :No.316 Xinggang Road ,Jinan city,China 25000
Tel:0086-531-88558038
Mobile:0086 15179191743
E-mail:xintian122@xtlaser.com
Website; http://www(dot) xtlaser(dot)com/
