How to solve the burr problem of laser cutting machine?-Flora

How to solve the burr problem of laser cutting machine?

How to solve the burr problem of laser cutting machine?

During the cutting process of the metal laser cutting machine, due to improper operation and technical problems, the processed materials should not produce burrs. Why is there burrs? In fact, burrs are excessive residue particles on the surface of metal materials. If a piece of material has burrs, it can be qualitatively defective. The more burrs, the lower the quality.  Then, how to solve the burr problem of laser cutting machine?

The working principle of the laser cutting machine, technical analysis has obtained the cause and solution of the burr.

First, there is a deviation in the up and down position of the focus of the beam
Solution: adjust the position of the focus and adjust it according to the offset position it produces

Second, the output power of the machine is not enough
Solution: First, check whether the laser cutting machine is working normally. If it is abnormal, then it needs to be repaired and maintained in time. While, if it is normal, check whether the output value is correct.

Third, the wire cutting speed of the cutting machine is too slow.
Solution: timely adjust and increase the wire cutting speed

Four, the purity of the auxiliary gas of the cutting machine is not enough.
Solution: explain to improve the purity of auxiliary gas

Five, the laser beam of the cutting machine is offset.
Solution: Debug the focus and make adjustments in time

Six, the instability of the laser cutting machine operating for too long.
Solution: Turn off the machine and restart it and let the machine rest
Another reason is the quality of the equipment itself, as well as the parameter setting factor. After the customer purchases the laser cutting machine, a professional operator must debug the equipment.

Solutions for burrs in sheet metal processing by laser cutting machines:
First, an air compressor is necessary and use auxiliary gas for cutting.
Second, find a professional operator to debug the parameters of the laser cutting machine until it is normal.

XT laser is manufacturer of laser  machines  since 2004, any inquiry, feel free to contact us:

Email: xintian131@xtlaser.com

Skype: XTlaser-Flora

Mobile/Whatsapp/Wechat:0086 18354256184

Web: www.xtlaser.com

    Teklif Al

    Need Help?

    Fill out the form below and support will be available within the hour!