Laser cutting machine operation specification
Laser cutting machine operation specification
XT Laser Cutting Machines
Correct operation of the laser cutting machine is conducive to safe production, the enterprise individual is very important, in addition to be familiar with the correct operating procedures, but also familiar with the maintenance. Laser cutting machine operation process
1, according to the provisions of the wear good labour protective equipment, in the laser beam near the protective glasses must be worn in accordance with the regulations.
2, equipment start-up operators shall not leave their posts or trustees to be managed, such as indeed need to leave should stop or cut off the power switch.
3, the fire extinguisher should be placed within reach; not processed to switch off the laser or light gate; do not place paper, cloth or other flammable materials near the unprotected laser beam.
4, keep the laser, the bed and the surrounding site is clean, orderly, no oil, workpiece, plate, waste materials in accordance with the provisions of the pile.
5、After starting the machine, you should manually start the machine in X and Y directions at low speed to check and confirm that there are no abnormalities.6、After inputting the procedure for new workpieces, you should try to run it first and check its operation.
7、When working, pay attention to observe the operation of the machine tool, so as not to cut the machine out of the effective range of travel or two collision caused by accidents.
8、When using gas cylinders, you should avoid crushing the welding wires to avoid leakage accidents. The use of gas cylinders, transport should comply with the gas cylinder monitoring procedures. Prohibit gas cylinders in the sun burst or near the heat source. When opening the bottle valve, the operator must stand on the side of the bottle mouth.
9, maintenance to comply with high-pressure safety regulations. When maintaining every 40 hours of operation or every week, every 1000 hours of operation or every six months, follow the regulations and procedures.
Laser cutting machine maintenance
Cleaning the water tank:Firstly, turn off the power, unplug the water pipe at the water inlet, let the water in the laser tube flow into the water tank automatically, open the water tank, take out the water pump, and remove the dirt on the water pump. Clean the water tank, replace the circulating water, restore the water pump back to the water tank, insert the water pipe connecting the water pump into the water inlet, and tidy up the joints. Energise the water pump alone and run it for 2-3 minutes (to fill the laser tube with circulating water).
Fan cleaning:Fan for a long time, will make the fan inside the accumulation of a lot of solid dust, so that the fan produces a lot of noise, but also not conducive to exhaust and odour removal. When the fan suction is insufficient to exhaust poor adjacent to the first turn off the power supply, the fan on the inlet and outlet air ducts removed, remove the dust inside. Then turn the fan upside down. And pull the wind blade inside until clean, and then install the fan.
