Cutting machine body comparison-Acerina

Cutting machine body comparison-Acerina

Iron casting VS High thickness metal frame working bed.Cutting machine body comparison

Firstly, there will be some disadvantages among iron casting working bed.

Especially, many fiber laser cutter suppliers will use the iron casting bed, while mainly are the low quality metal. thus it is so hard to guarantee the working bed’s performance.What’s more. In current market, many iron cast working beds are no more than 3T, which is unreasonable. Because some suppliers want to save cost, so they will do something at the working bed.

Cutting machine body comparison.In general.

First of all, there will surely be some faults in Iron casting machine bed. especially for current factories, who produce machine beds. Most of them only choose some mixed, not good quality irons, as a result, machine quality can not be assured.

Also, in market, total weight of iron casting machine bed is no heavier than 3 tons, which is absolutely terrible. This is surely because manufacturers want to make more profits.So they use less materials. Because normally one standard 1530 iron casting machine bed is at least 4-5 tons.

All in all, some suppliers only use IRON CASTING MACHINE BED for an advertisement.

 

Second, Casting Iron Machine Body will have many bubble inside and we can’t check it by ordinary equipment. these bubble will make bed not solid. After long time running. Machine bed may breakage

 

Third ,once the screws on machine bed are loose, hard to fix it.

During fiber laser cutting machine running processing, there is many shake, after several months, machine bed have big problem

 

XT LASER choose Thick plate welding machine bed
  1. This kind of machine bed has strongly reasonable structure, it is produced by relief annealing, so the whole structure is very firm and hard to be deformed.

 

  1. For thick plate welding machine bed, inside the metal plates are solid. So, even after long time of running, it will still remain stable.

 

  1. After long time of using , some screws may become loose, but do not worry. Because you just make screws mor e tight, that is all.

No need worry about loose screws.

Casting Aluminium Gantry VS Manganese Steel Gantry

In fact, nowadays, in market, there are two common gantries, one is Welding Tube Gantry & Casting Aluminium Gantry.

Welding Tube Gantry, this gantry is too heavy, so it will restrict accelerating speed of machine. And then Casting Aluminium Gantry was born.

But Casting Aluminium Gantry , it is light, and can make accelerating speed higher.

But it has no same rigidity as Welding Tube Gantry, so there will surely happen: Loose screws, Deformation .etc . These problems will occur after a period of time.

What is worse, in market, most of the Casting Aluminium Gantry is never under Hot Treatment, so there will be 0.05- 0.1mm deformation after one year or two years. This will be terrible.

 

    Obtenha uma cotação

    Precisa de ajuda?

    Preencha o formulário abaixo e o suporte estará disponível dentro de uma hora!