Operation steps of fiber laser cutting machine:

1. Determine the material processed, place the sheet metal material on the processing machine, and then determine the stability of the material placement, so as not to shake during the cutting process, resulting in insufficient cutting accuracy.

2. Operate the console, enter the product cutting pattern, and the thickness of the cutting material and other parameters, and then adjust the cutting head to the appropriate focus position, and then reflect on and adjust the nozzle center.

3. Start the regulator and the chiller, and set the water temperature and pressure of the chiller.

4. Turn on the laser, and then turn on the machine.

Although the above four points are very brief, in the actual operation process, it takes a lot of time to practice and familiarize with the details of each operation. It is inevitable that there will be some failures and problems when operating the fiber laser cutting machine. Let me summarize and share it below.

1. There is no response at boot

◆ Whether the power fuse burnt out: replace the fuse.

◆ Whether the power input is in normal: check the power input and back it to normal.

◆  The main power switch damaged: So, replace the main power switch.

2. No laser output or weak laser

◆ To check if is the optical path offset: Adjust the optical path carefully.

◆ The focal length of the device has changed: So, readjust the focal length.

◆ The laser tube is damaged or aging: replace the laser tube.

◆  Whether the laser power supply energized: Check the laser power supply circuit to make it normal.

◆ Whether the laser power supply damaged: So, replace the laser power supply.

3. The processing size has errors or movement errors

◆ Whether the signal cable is normal: replace the signal cable.

◆ The power supply is unstable or has interference signals: install a voltage stabilizer or eliminate interference signals.

◆ Whether the processing parameters set correctly (such as layout, etc.): reset the corresponding parameters.

◆ Whether the processing program write normally: Check the written processing program and modify it until it is normal.

Operation steps of fiber laser cutting machine