Maintenance of Air Compressor in Fiber Laser Cutting Machine-Bunny
Maintenance of Air Compressor in Fiber Laser Cutting Machine
An air compressor use to compress gases. Because of it is a device for converting the mechanical energy of a prime mover (usually a motor) into gas pressure energy. And a pressure generator for compressed air. And so air compressor is an integral part of fiber laser cutting machine system. Because the following are the maintenance and maintenance of its main components.
1.Air filter. first of all in general every 500 hours to clean air filter surface dust impurities, besides that every 2000 hours to check whether it needs to be replaced.
In short the inspection or replacement cycle may be determined by reference instruction on the level of dust content.
2.Inlet valve seal. Another check the condition of the sealing ring for every 4000 hours of work in the air compressor of the laser cutting machine, replace it if necessary.
3.Compressor lubricating oil. Due to replace lubricating oil every 4000 hours.
4.Oil filter. Most importantly change every 2000 hours.
5.Oil vapor separator. Another need to change every 4000 hours.
6.Pressure valve. Therefore so clean every 4000 hours and check that the open pressure is normal.
7.Relief valve. Most importantly check for sensitivity every 4000 hours.
8.Fuel outlet valve. Discharge water and dirt every 2000 hours.
9.Drive belt. And the tightness every 2000 hours besides that check the wear condition every 4000 hours therefore decide whether to change according to the wear condition.
10.Motor maintenance. Maintenance according to motor usage instructions.
Finally in order to make the air compressor of laser cutting machine run normally, therefore XTlaser reminds you to draw up the detailed maintenance plan, execute the fixed person operation, regularly maintain, check and maintain regularly, therefore make the air compressor group keep clean, oil free, no dirt.
