Laser Cutting Machine Maintenance In Summer

In summer, due to rising temperatures, the air humidity is high.

1.The scientific maintenance of the laser cutting machine can prevent many small problems in use, summarized as follows:

The cooling water temperature of the idea should not be too different from the air temperature. The laser and optical lens of the laser cutting machine are used for water cooling. The water in the air will condense into water when it is cold. When the cooling water temperature is lower than room temperature. At -7 degrees, there is condensation on the surface of the laser and the optical lens.

2.Which greatly affects the light-emitting efficiency of the laser and the transmission of the optical lens.

Which has a great influence on the laser energy and the service life of the optical component. It is recommended that users of large laser cutting machines set the water temperature to 30-32 degrees. And control the temperature difference between the cooling water temperature. And the room temperature to be greater than 7 degrees.

3.The temperature rises in summer and the working pressure of the cooling system of the laser cutting machine increases.

We recommend to check the internal moderate pressure of the cooling machine before the high temperature comes. The equipment pressure of different manufacturers is not the same. We recommended to consult the equipment manufacturer before maintenance. parameter.

4.In summer, due to the higher temperature, the deterioration rate of cooling water will also be accelerated.

We recommend it that users of laser cutting machines use regular distilled water or pure water. And regularly clean the scale to avoid causing the scale of the laser,and the pipe to affect the laser power. The method of cleaning the scale by different types of laser cutting machines is also different. Please operate under the guidance of the equipment manufacturer.

5.Since the dust of the metal laser cutting machine is mainly metal powder.

We recommend to regularly clean the dust in the electrical cabinet of the laser cutting machine. And check the work of the cooling fan.

Hope these information is helpful for you.

If you have any questions of machine,please contact us.

Sales Manager:Anne Zhang

Mob/whatsapp:+8615098735595

Skype:amyzhang1321

Email:xintian121@xtlaser.com