Laser cleaning machine specification -2-Tulsa

Laser cleaning machine specification -2-Tulsa

We shared any fiber laser cleaning machine specification on Monday.

So now let us share more with you, hope it will help you.

1.Introduction

Laser cleaning system is the new generation product.

With a high technology applies for the purpose of the material surface cleaning application.

And which is easily to set up, operated and automated.

Besides no need of chemistry, water or other working medias.

The equipment can be also applied for removing the resin, grease, stains, dirt, rust material, coating, coating and paint.

So this device can be auto-focused on a specified area of the target surface of the material.

And which leads to a high performance of cleanliness result.

2.1 Features of equipment

1)No damage to the base of the material due to the no-touch surface cleaning performance
2)Besides precise cleaning technic for the specific area in a selected area
3)No need of chemistry or other added supplies
4)Easy to operate, can be hand-held or auto-cleaned by installing a robotic arm
5)Small cleaning time consumption and comes with a high quality finishing result
6)Stable and impacted integrated design which results to no extra maintenance

2.2 Application Industries

Ships Auto parts Rubber mold CNC Tire mold
Rail Environmental protection and else

Paint cleaning Oil dirt cleaning

Oxide layer cleaning Screw cleaning

Tire mold before cleaning after cleaning

Steel rust cleaning welding joint cleaning

 

3 Installation and Adjustment

3.1 Operating Procedure:

1:Connect the power supply(220V,50Hz)with cable,red one for Live Wire,black for Null Wire,yellow for Earth Wire;
2:Check the water level of the chiller,make sure the water in chiller is enough before turn on the power-supply switch.

3.2 Attentions

1、Taking the cleaning head directly toward people is forbidden, as well as high reflectivity materials(copper,aluminum…).
2、Then taking on labor protection appliance and eyewear when using.
3、And the alarm light will  on if laser machine hasn’t turned off properly and service life will influence. Users are suggest to check every button weather they are reset or not before power supply.
4、It’s forbidden to make cleaning head at a right angle to materials.
5、Change water in chiller every 3-6 months with deionized water.
6、The bending radius of corrugated pipe must no smaller than 250mm(≥250mm).Two positions as pictures show below should protect properly and avoid being bent excessively.

    Get a Quote

    Need Help?

    Fill out the form below and support will be available within the hour!