Laser cutting machine is a modern commonly used processing equipment.

When processing, there will always be some headaches, especially the laser cutting machine resets abnormally. This is also a question that everyone is more concerned about. In such a situation, how do we do it?
The laser cutting machine has a lot of attention since its use. The laser cutting machine is not only used in the process, but also requires a certain understanding. Laser cutting machines often have problems such as engraving and initialization. Here you need to do Correcting the data can solve the problem.
Laser cutting machine’s engraving, initialization is incorrect, data has been sent (corrected):

1, the operation order is reversed (re-entered); static interference (check whether the ground wire is off); (Reset);

2, the computer system is wrong (reinstall the operating system and software);

3, check whether the left and right belts are consistent or the back-end belt is too loose (belt tightening);

4, check whether the belt or timing pulley is slipping or jumping (intensifying the timing pulley or (Belt);

5, check if the beam is parallel (readjust left and right belts).

There are several reasons for the abnormal reset of the laser cutting machine:

The X-axis and Y-axis of the laser cutting machine move in opposite directions and hit the side end. This phenomenon should check whether the parameters of the main board are wrong, and stop the machine to check whether there is a problem with the parameter settings of the main board.
The control panel of the laser cutting machine is normal, and the X-axis and Y-axis are not moving. You can try to unplug the sensor terminals of the main board to see if the machine is moving. In this case, consider replacing the sensors.
The beam is reset normally, and the X-axis of the laser cutting machine is reset. The motor wire may be broken or the motor shaft may be broken. In this phenomenon, the motor wire or the small motor must be replaced.
When resetting, the direction is correct, but at the apex, the X-axis or Y-axis cannot be stopped (check the motherboard parameters first). If it is correct, check the motherboard or sensor for this phenomenon, and replace and eliminate it.