Is the fiber laser welding machine fully loaded for a long time?

Is the fiber laser welding machine fully loaded for a long time? Fiber laser welding machines are expensive equipment, so many customers tend to choose smaller models to reduce costs.

In terms of procurement costs, this is understandable. But if the product you are welding is relatively thick, it needs continuous mass production for a long time. Low-power models are difficult to meet the corresponding welding requirements of the product. At this time, customers often use a laser welding machine at full power to complete the welding process. Is this good for laser equipment? In fact, this is very bad.

First, the main components of the laser power supply: full power use is like the car long-term running 120, easy to lead to laser power (mainly provide power source) aging, and related electronic and optical components aging, shorten the life of components.

Second, the main components of the laser xenon lamp and crystal: the consumption rate of consumables increased, such as a xenon lamp normally shines 1 million times, long-term full load operation will be reduced to hundreds of thousands of times, the lens temperature rise during full-time full load operation And the coating surface damage is intensified, and it is easy to cause pollution and cracking.

Third, the main components of the laser chiller: the chiller starts and stops the high-frequency operation, the internal compressor and the main components are very large, shortening the service life of the chiller.

Therefore, we recommend that customers choose the fiber-optic laser welding machine, first consider the material, thickness and other factors of the welding product, and then choose the model that is suitable for power. This not only achieves the best welding results, but also increases the service life of the equipment.

Contact:Karina

Wechat & whatsapp:008618206584205