How to maintain the cutting machine?

Here are some details about the maintenance of  the cutting machine after using it.

• Above all,clean.

Firstly,we need to clean the attached dust and cut slag on the surface of the equipment.

Secondly,clean up the water in the A/C storage tank.

Thirdly,cleaning waste scraps and debris in waste trailers.

More over,clean the dust on the A/C dust cover net and the water cooler dust cover net.

Fifthly,clean the water tank of the water cooler.

Last but not least,clean the surface of the cutting head and focus on cleaning the cooling water pipe joint, auxiliary gas joint, protective lens window, QBH/QCS joint and other parts.

• What’s more,check.

Firstly,check the joints of the capacitor signal module (at the cutting head) to confirm that the fastening is intact and there is no looseness.

Secondly,equipment homing(including X, Y and Z axes).

More over,check the lubricating oil level in the lubricating oil pump. If it is not enough, fill it in time.

Fourthly,check the lubrication condition of each shaft slide rail, rack, gear and z-axis screw; and manually add lubricating oil on the upper end surface and the two end surfaces of the guide rail, and the main mechanical linkage end face of the rack, gear and lead screw is evenly distributed. Apply lithium grease. (If there is rust, be sure to remove the rust first.)

Fifthly,check the water pipes of the cooling water pipe to confirm that there is no extrusion, bending, grinding, scratching and water leakage; check the water pipe joints (push-in connectors and ordinary threaded joints) to confirm that the connection is normal and there is no water leakage.

Sixthly,check if the cooling water pressure gauge value is normal.

What’s more,replace the water cooler to circulate cooling water.

At last,check the wiring harness and cable everywhere, and confirm that there are no extrusion, bending, grinding, and scratching. There is no open welding or short circuit or hidden trouble in the welding of the break point and the plug joint.

That is some of the maintenance of  the cutting machine after using it .

Mob/Whatsapp:+8613731273956

WeChat:xtlaseroriole

Email:xintian161@xtlaser.com

Skype:xintian161@xtlaser.com

web:www.xtlaser.com