Installation steps of fiber laser cleaning machine

Steps:

Step 1: Take out the power cable, connect the 220V/50Hz power supply, red to the live wire, black to the neutral wire, yellow ground wire.

Step 2: Check the water level of the water tank. If the water level is too low, please add water and then plug on; if the water level is normal, turn the air open switch upwards, the whole machine is energy, check whether the water tank is working normally

Step 3: Button operation, as shown below.

Frist,Reset the “Emergency Stop” button;

Then, The “power” key switch is turn to the right to turn on the power of the control system, and the green indicator light is on; And Press the “Laser” button and the laser green button light is on;

Step 4: Turn on the cabinet to turn on the laser.

First,Check if the “LASER” button is reset. If it is not reset, reset the “LASER” button; and reset the “Emergency Stop” button;

Then,The “power” key switch is turn to the right and the “POWER” green indicator light is on;

Also,Press the “LASER” button, the “LASER” red indicator light is on; note that if the “ALARM” indicator is on, the laser is in the alarm state, please shut down and contact sales.

Step 5: Open the top cover of the chassis and take out the cleaning head, as

shown below. It is forbid to point the laser output head to a person’s position, and the laser output head is prohibit from illuminating the surface of the high-reflection material (such as copper, aluminum, mirror stainless steel and other highly reflective materials)

In next parts,we will continue to sharing with more info. of Installation steps of fiber laser cleaning machine.

Whatsapp:0086 17864184107