Application of fiber laser cutting machine in sheet metal processing

Application of fiber laser cutting machine in sheet metal processing. Many customers who have not been exposed to fiber laser cutting machines have great doubts about the quality of laser cutting machines.
In fact, there are many ways to cut metal. In addition to traditional shearing machines and combined punching machines.

What’s more, there are also hot cutting methods including plasma cutting machines and laser cutting machines.
Among them, the metal laser cutting machine adopts the numerical control system, which can cut and engrave complex patterns on the thin plate, and has excellent precision.

It can also apply  in the metal thick plate cutting, and it widely use in the field of sheet metal processing!

Cutting stainless steel

Stainless steel apply  in a wide range, such as kitchen equipment, general tensile materials, gas stoves, refrigerators, electrical appliances, washing machines, building materials, regrind, elevators, interior and exterior decorative materials, chemical equipment, heat exchangers, boilers, etc. You can see the figure of stainless steel!
Stainless steel laser cutting is a fast and effective processing method! Not only cost less than the traditional wire cutting, but also twice the speed of wire cutting, can achieve high-volume production.

Cutting carbon steel

Fiber laser cutting machine is widely use in carbon steel cutting. The advantage of carbon steel laser cutting machine is that it can cut any design pattern on the board, with high speed and high precision. It can forme in one time without subsequent processing.
Moreover, the laser cutting machine cuts carbon steel without casting, saving cost, visually discharging, and closely fitting, saving materials.

Cutting non-ferrous metals

Cut non-ferrous metals (copper and brass) also use fiber laser cutting machines.
Both materials have high reflectivity and very good thermal conductivity.
It can cut brass with a thickness of 1 mm or less by nitrogen laser cutting. What’s more,it also can ut copper with a thickness of 2 mm or less. And it must use oxygen for laser cutting processing.
It should be noted that when cutting copper and brass, a “reflective absorption” device is required on the system.