Fiber laser cuter auto focus and manual focus-Huda
Fiber laser cuter auto focus and manual focus
Fiber laser cuter auto focus and manual focus
In the early application of fiber laser cutting machine, because there is no auto focus, the laser cutting machine needs to focus manually;
this focusing method not only has certain requirements on the technical level of the operator,
but also has a certain degree of product accuracy and production efficiency. influences.
laser cutter
With the continuous improvement of production requirements, new auto-focusing laser heads came out,
traditional manual-focusing laser heads were gradually eliminate, and new auto-focusing laser heads were widely use.
The piercing focus of the manual focus cutting head cannot be adjusted.
The piercing focus is the same as the cutting focus. When cutting thick plates, the punching energy is insufficient and the punching time is long.
The perforation focus of the auto-focus cutting head can be adjusted, the focus can be adjusted to increase the perforation energy during perforation,
and the perforation speed can be increased during the perforation of thick plates.
In terms of perforation time, auto focus is more than twice as fast as manual focus, and the cutting effect is basically the same,
but auto focus will reduce the over-melting of the sheet due to the short material overheating time.
The advantage of auto focus is obvious; Improve production efficiency, greatly reduce the perforation time of cutting thick plate materials,
and can process workpieces of different materials and different thicknesses.
The machine can also quickly adjust the focus to a suitable position.
Therefore, the automatic focusing fiber laser cutting machine is ahead of manual focusing in most aspects.
With the advancement of technology, the automatic focusing laser cutting machine will be more practical and the processing effect will be more perfect.