Solutions for jewelry fiber laser cutting machine-Ivy
Solutions for jewelry fiber laser cutting machine
This is Ivy here from XTLASER,have worked in laser industry near to 4 years. And served over 300 customers before. Now more and more customers want to do engraving also cutting works on jewelry. Such as silver,gold and brass,thickness up to 2mm. To be honest,it is little embarrassed…Here two options about Solutions for jewelry fiber laser cutting machine.
*First is Fiber laser marking machine.
As we know,50w can cut 0.1-1.2mm thickness jewelry plate. And 100w has no big difference cutting ability with 50w. But the cutting speed is little faster than 50w power. Such as 50w takes 7 mins but 100w can finished that within 5 mins. Is it clear? And this marking machine can do marking and engraving works very smoothly.
*Second is Fiber laser cutting machine.
As for 1.5-2.0mm jewelry plate cutting,at least need 1000w laser power to cur. Yes. The machine can cut though material one time. But,as for Fiber laser marking machine have to mark on material one layer by one layer. And after many times marking. Then cut it down. So the fiber laser cutting machine will be faster than marking machine! However. The question is big cutter machine not suitable to mark and engrave on metal.
| 50w marking machine with 100*100mm lens | 1000w n-Light with 600*600mm working area |
 |  |
| *Molde:XTL-F50/100. *Machine outlook:open type. *50w/100w Raycus laser source . *come with 2D working table. | Model:XTC-FM6060. Machine Outlook:Enclosed type. Fiber Laser source:n-Light. Laser Head:Raytools. Transmission system:Dual-drive, precise Ball Screw . Crossbeam:aliuminum. Guide rail:Taiwan HIWIN. Speed Reducer:Motorreducer. Motor:Servo motor: Fuji/YASKAWA, Japan. Principle Y axis use 2 sets of motor,X axis use 1set,Z axis use 1 set of motor. water chiller:Hanli& Tong fei. Control System:Cypcut. |
And here is comparison of different machine:
| As for Advantages | As for Disadvantages | |
| About Fiber laser marking machine | *Lower machine cost; *Easy to learn and operation; *Fast production time; *Can do marking,engraving & cutting; *No wearing parts; *Support ring inside and outside marking; | *Cutting speed is slow; *Max only can cut 1.2mm; |
| About Fiber laser cutting machine | *Fast cutting speed; *Can cut up to 2.0mm jewelry plate; | *Machine cost is higher; *Need about 4-5 weeks for production; *Need our engineer to your factory for installation and training; *Has wearing parts on cutting head,such as protective lens and nozzle; *The machine size is bigger; *Not suitable for marking and engraving; |
Based on our experience. 95% customers would like to chose Fiber laser marking machine.
Hope it can help you.
Email:xintian108@xtlaser.com
Wechat/whatsapp:0086 17864184107
